Bitumen-rubber mastic taping IZOPLAST W-KL
Bitumen-rubber mastic IZOPLAST W-KL is suitable to perform seamless waterproofing vertical and horizontal surfaces as well as bonding of thermal insulation materials.
Read articleIzoplast W-KL - bitumen-rubber mastic, water based for light, seamless waterproofing coverings. For gluing of plates from polyfoam, polystyrene foam (EPS, XPS) and mineral insulation to concrete, brick and plastered surfaces.
Applications:
Advantages:
Instructions for use:
Prior to use mix. The surface should be smooth, free from dust and dirt. The concrete surface should be primed with IZOPLAST DYSPERBENT, or, if necessary, apply a proper waterproofing layer.
For use as a waterproofing layer well mixed, the mass Izoplast W-KL applied to the surface by brush, trowel or roofing brush.
For gluing of plates from polyfoam or polystyrene Izoplast W-KL is applied to the plate lines, with a width of 4 cm and a thickness of from 1.5 to 5 mm around the perimeter at intervals of 30 cm, or 20 points with a diameter of 5-10 cm per 1 m2.
Remarks /Restrictions:
Observe safety precautions and labour protection during execution of works. Use protective gloves, clothing, glasses. After contact with skin wash with plenty of soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice. Work with IZOPLAST W-KL carried out in calm weather without precipitation at ambient temperatures from 5 °C to 25 °C.
Composition |
Bitumen-rubber emulsion water based |
Color |
Black |
Packaging |
A bucket of 20 kg. |
Drying time |
≤ 6 hours |
The interval between coats |
3 hours |
Consumption (hydro) |
0,6-1,0 kg/m2 |
Consumption (bonding plates XPS) |
0,8-1,2 kg/ m2 |
Water resistant using |
6 hours |
Application temperature |
from - 5 °C to 25 °C |
Dry mass residue |
75 % |
Bitumen-rubber mastic IZOPLAST W-KL is suitable to perform seamless waterproofing vertical and horizontal surfaces as well as bonding of thermal insulation materials.
Read article