Bitumen mastic, water-based Teknomer 400 W

A modified single component bitumen mastic, water-based Teknomer 400 W with special polymers. Creates a seamless protective layer of structures and buildings from groundwater and moisture.

Applications:

• retaining walls and foundations
• concrete terraced roof
• the balconies and open terraces
• galleries, drainage and drains, manifolds
• open reservoirs for drinking water and swimming pools

Advantages

• completely ready to use
• contains no solvents
• can be used for vertical concrete surfaces
• apply cold way
• does not require heating and/or dilution
• fast curing
• creates a solid (seamless) insulation layer
• water-based and has good adhesion to damp surfaces

Usage instructions

Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks, cavities on the surface - they must be repaired using the easy cement mixes Teknorep 300 and Teknorep 300 EX. The insulated surface must be dry and prepared. If, before applying TEKNOMER 400 dilatation of the design, it must first be insulated with tapes Teknomer Pah Band 120/70 and Teknobond 400 D.

Recommendations for the use of

• Before application mix with low speed mixer until a homogeneous mixture. The mixing time is not less than 5 minutes. The material is ready for use and requires no dilution with water or other liquids. Do not apply under direct sunlight.
• Material ready-to-use, is applied to the surface with a wide brush or spray. Apply in two layers. The direction of deposition of each layer must be perpendicular to the previous one. The amount of time between coats for at least 1 hour. To increase adhesion between the layers, you can use fiberglass or reinforcing mesh.
• After application protect surface from adverse weather conditions such as direct sunlight, strong wind, high air temperature (above 35 ° C), rain and frost. Equipment immediately after use must be cleaned with a solvent.