Bitumen-rubber mastic Izoplast Dysperbent

Izoplast Dysperbent – bitumen-rubber mastic, water-based modified with synthetic rubber.

Applications:

• Repair and maintenance of roof
• Waterproofing foundations
• For waterproofing of residential and public buildings
• Priming mineral bases for proper insulation
• Seamless waterproofing vertical and horizontal surfaces

Advantages:

• Water soluble, no organic solvents
• Resistant to weak acids and salts
• For outdoor and indoor use
• Ready to use, odorless
• Very high adhesion to the base
• Has thixotropic properties
• Does not react with EPS and XPS polystyrene, can be used in conjunction with materials not resistant to organic solvents and their pairs
• Easily applied by brush or spray

Instructions for use:

Prior to use mix. The surface should be smooth, free from dust and dirt. Concrete, gypsum, ceramic, etc. surfaces must be primed with a solution DYSPERBENT diluted with water in 1:1 ratio.

Do not store diluted solution. To protect the waterproofing from mechanical damage to underground parts of the building to use "Dysperbent" using a thorn of the membrane.

Prior to use mix. Apply the mass using a roofing brush, brush or spatula at temperatures from 5 °C to 25 °C and in wet weather. The drying time of the coating layer at a temperature of 20 °C is 6 hours. Depending on the need to apply the material in 2-3 layers. Each subsequent layer applied after drying the previous one. Can be used on slightly wet surface, then drying time of the coating increases. Coating becomes waterproof only after complete curing.

Remarks / Restrictions:

Observe safety precautions and labour protection during execution of works. Use protective gloves, clothing, glasses. After contact with skin wash with plenty of soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice.