A two-component mixture Teknomer 200 EX Crystallized

Directory > Materials for waterproofing

A two-component mixture Teknomer 200 EX Crystallized

Crystallized two-component flexible waterproofing and protective material.

CHECKOUT

Введите свои данные

Crystallized two-component flexible waterproofing and protective material Teknomer 200 EX. Forms a seamless flexible waterproofing coating. Creates protection from leaks and penetration of surface waters. Consists of powder component based on cement, the liquid component, based on acrylic and special additives that enhance the workability and water-resistant surface coating.

Applications:

  • for indoor and outdoor use
  • for vertical and horizontal surfaces
  • for rooms with high humidity (bathrooms and showers, balconies, terraces and cellars)
  • for foundations and exterior walls of the basement
  • for concrete, brick and plastered surfaces

 

Advantages

  • resistance to negative and positive water pressure.
  • has a high adhesive strength
  • prevents carbonation in concrete
  • applies to all types of stone and brick, aerated concrete, concrete blocks, limestone
  • can be applied manually or by spray

 

Usage instructions

Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks and cavities on surface should be repaired using the easy cement mixes Teknorep 300 and Teknorep 300 EX. If you have an active water leak, it needs to be addressed through Teknoplug.

Before application the surface should be moistened. The application surface should be protected from sun, rain and dust for 1 day and should not be applied under direct sunlight.

The liquid component should be placed in a clean container, proportioning for mixing, slowly add the powder mixture and mixed thoroughly with a slow speed mixer (500 rpm) for 5 minutes. Stand the solution for 3 minutes and continue mixing until a homogeneous mass.

The prepared solution should be applied to the surface in 2 or 3 layers with roller or brush. The direction of deposition of each layer must be perpendicular to the previous one. The time interval between coats of at least 3 hours. The total thickness of drawing of 3 mm will suffice. The corners and joints surface application should be sealed elastic adhesive tape for sealing construction joints Teknomer Pah Band 120/70. After application the surface should be protected from direct sunlight, frost and wind not less than 1 day.

The composition of the material

Component A: grey powder

Component B: white liquid

Packaging

25 kg (A) 10 l (In)

Shelf life

12 months in dry environment in unopened container

Application temperature

( 5 ° C) - ( 35 ° C)

Consumption

1.8 kg/m2 (at a thickness of 1 mm)

The pot life of the mixture

45 minutes

Applying the second layer

3-6 hours

Ready to use

7 days

The density of the mixture

1.8 kg/l

Commissioning

3-7 days

Adhesive force

1 N/mm2

Penetration into cracks

≥ 2.5 mm

Waterproofing

10 Bar (positive)

10 Bar (negative)