Тeknomer 100 - single-component crystallized waterproofing material based on cement. Surfaces resistance to negative and positive water pressure. Included in the material composition insoluble crystals fill the pores of the concrete, preventing water penetration.
Applications:
- tunnels and lift shafts
- ground floors and basements
- showers and bathrooms
- pools, wells and water tanks
- reinforced concrete pipe
- large engineering structures
Advantages:
- penetrates deep into the concrete base
- resistant to negative and positive water pressure
- can be applied manually or by spraying
Instructions for use:
Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks and cavities on surface should be repaired using the easy cement mixes Teknorep 300 and Teknorep 300 EX.
* If the insulated surface is dry, it should be wet. If there is an active leak, it must be eradicated material Teknoplug.
In a clean container add 6-7 liters of water and gradually pour into it Teknomer 100 while stirring at low speed using a low shear mixer, until a homogeneous mass. The mixing time should be not less than 5 minutes, then leave the solution for 3 minutes at rest, and mix again for 2 minutes.
- The brush
The prepared mixture is applied on the surface with a brush in 2-3 layers. Layers should be applied perpendicular to each other.
The waiting time between layers is kept such that the previous layer did not stick to the fingers.
2. Spray
Teknomer 100 is sprayed on the prepared surface evenly.
* To use Teknomer 100 as an additive for concrete, you must mix the solution after adding in the total volume of the mixture Teknomer 100 and further mixed for 5-7 minutes.
Remarks / Restrictions:
- Do not use on surfaces made of wood, chipboard, MDF, plywood, PVC and metal.
- Use gloves, mask and goggles during work
- Use the recommended proportion for mixing
- The surface after application of the solution must be protected from adverse weather conditions such as direct sunlight, strong wind, high air temperature (above 35 °C), rain and frost.
- Used tools and equipment must be cleaned with warm water immediately after use.
Color
|
Grey
|
Shelf life
|
12 months in dry environment in unopened container
|
Packaging
|
20 kg bag
|
Application temperature
|
( 5 °C) - ( 35 °C)
|
Mix ratio
|
6-7 litres water / 20 kg powder
|
The life time of the mixture
|
20 min.
|
Full cure
|
5 days
|
Water resistant
|
7 Bar (positive and negative)
|