Self-leveling screed Teknoself 500

Directory > The materials for industrial floors

Self-leveling screed Teknoself 500

Flanny self-leveling mortar for screed with additives synthetic polymer.

1200
uah
x
bag
=
1200 uah
Wholesale price 1020 uah from 10 bag

For you, there will be a greater sense of the price of the proposition. Be affectionate, send a request and managers create an individual prorachunok for you.

CHECKOUT

Enter your name and phone number

Teknoself 500 – reinforced self-levelling mortar for screed with additives synthetic polymer and improved adhesion strength.

Scope

  • Used as a levelling screed for the preparation of surfaces under tiles, ceramics, granite, marble, parquet, linoleum, carpet. For use indoors and outdoors.
  • To create surfaces with high resistance to loads (shops, exhibition areas, industrial sites).
  • For areas where you need to pour self-leveling coating thickness more than 10 mm.


The features and benefits

  • Easy to apply.
  • Fast curing, the surface is ready for foot traffic after 2 hours, fully cured after 15 hours.
  • Has high adhesion.
  • Makes the surface perfectly smooth.
  • Does not crack.
  • After curing, the surface is ready for coating with a protective material Teknocila 300.


Usage instructions

Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. The surface should be cleaned using appropriate methods to ensure maximum adhesion strength. If there are areas in the form of cracks and cavities on surface should be repaired using the easy cement mixes Teknorep 300 and Teknorep 300EX. For better adhesion of the prepared surface must be primed TEKNOLATEX TEKNOLATEX 500 or 300, depending on its structure. Dry surfaces should be slightly dampened. Apply TEKNOSELF should start in 3-4 days.

The prepared material is spread evenly over the primed surface. To eliminate air bubbles is recommended to use a spiked roller. To mix the solution recommend by using a low speed electric mixer (max 400 rpm) until a homogeneous mixture. In a container add 5 - 6 liters of water, then slowly add the powdered material, mixing continued to obtain a homogeneous mixture. The amount of water for mixing may vary depending on the ambient temperature. Solution should be used and spread on the surface for 30 minutes.


Notes on application / Limitations

  • After pouring, the surface should be protected from adverse weather conditions such as direct sunlight, strong wind, high air temperature (above 35 °C), rain and frost.
  • The floor temperature should not fall below 10 °C during curing.
  • The floor should be protected from contact with water after application.
  • For operation the surface in open spaces it is covered TEKNOCILA 400 to increase resistance to the effects of the environment.
  • Used tools and equipment must be cleaned with warm water immediately after use.

Color

Grey

Shelf life

12 months in dry environment in unopened container.

Packaging

25 kg bag

The particle diameter of the

≤ 0.3 mm

Application temperature

( 5 °C) - ( 35 °C)

The mixing ratio

5 - 6 l water / 25 kg powder

The life time of the mixture

20-30 minutes

The density of the solution

1,8±0,1 kg/l

Consumption

1.8 kg/m2 (at a thickness of 1 mm)

The thickness of the coating

10-30 mm

Flexural strength (28 days)

≥ 5,0 N / mm2

Compressive strength (28 days)

≥ 25.0 N / mm2 (TS EN 196-1)