Strengthening toppings for concrete floors Teknoser 100 and Teknoser 300

Industrial concrete floors, which are subjected to various types of heavy loads, need additional strength in order to protect the surface layer of concrete from various types of deformations and thereby extend their service life.

It is for such purposes that the innovative concrete hardeners Teknoser 100 and Teknoser 300 have been developed.

 

Teknoser 100 is a hardener for fresh concrete surfaces, which includes sorted quartz sand, hydraulic binder and special chemical additives. It increases the strength properties of the concrete surface by 1.5 times and gives the necessary decorative appearance to the surface.

 

Teknoser 300 is a hardener for fresh concrete surfaces, which includes corundum chips, hydraulic binder and special chemical additives. This topping increases the strength properties of the concrete surface by 2 times.

 

 

Teknoser 100 and Teknoser 300 concrete hardeners are used for concrete floors of shops, department stores, underpasses, metro stations, covered parking lots, production workshops, warehouses, factories, shopping malls with heavy traffic, industrial buildings, gas stations and hangars for airplanes.

Now that we have an idea of what the Teknoser 100 and Teknoser 300 reinforcement toppings are, let's look at their application in more detail.

Teknoser 100 and Teknoser 300 toppings are applied using the "dry-on-wet" method, which means that the hardeners must be applied to uncured concrete (approximately 5-6 hours after pouring) for better adhesion of materials. The topping crumbles in an even layer at the rate of 2-4 kg / m2 and does not require additional watering, since the mixture will absorb the necessary amount of water from the concrete on its own. After the hardener absorbs moisture and darkens, it is necessary to treat the coating with a grout machine, paying special attention to the corners and edges of the surface. Then it is necessary to re-fill with the calculation of 2-4 kg / m2 and rub the surface again in the same way. Depending on the expected strength of the load on the floor, the consumption of the dry mixture may vary.

 

One of the main advantages of using Teknoser 100 and Teknoser 300 toppings is fast stacking. Which in turn helps to reduce the time of putting the coating into operation.

The Teknoser 100 and Teknoser 300 hardeners will significantly increase the resistance of your floor to impact and abrasion, as well as make its surface perfectly smooth, non-slip and smooth.