Water-resistant two-component, thixotropic, quick-drying hibanker.
Water-resistant two-component, thixotropic, quick-drying chemical composition based on synthetic epoxy acrylate resin.
Applications:
The features and benefits
Instructions for application:
Surface for application should be cleaned from dust, dirt, loose particles, residues of cement, oils and fats. The concrete substrate must be clean, durable and have adequate compressive strength.
Surface for application should be cleaned by applying compressed air to maintain maximum adhesion.
Temperature of surface and environment should be min 5 ° C. 35 ° C max.
In order to open the cover, turn it. Then, install static mixer. Place the cartridge into the gun and start application. When you stop the coating process, the tip of the static mixer can be left on the cartridge after the pressure in the atomizer is released. If in a static mixer resin is hardened, before you start, you need to install a new insert. When you store an open cartridge, remove the static mixer, turn it, wipe the neck of the cartridge with a clean dry cloth and close the cover.
Application method: Drill a hole of required diameter and depth using the drill. The diameter and depth of the hole should match the size used anchor element. The hole should be cleaned from the inside round wire brush and compressed air. Then hold the trigger until the two separate components of the cartridge will not come out of the static mixer. Slowly pull the cartridge, filling the hole with resin starting from the bottom of the hole. Make sure that inside there are no air gaps.
In deep holes, you can use an extension cord. Rotate the anchor when you insert it. If a certain amount of resin came out, the anchor element should be placed at the hole during the period of gelation of the resin. During hardening, in any case can not move or load the anchor element. During application should be used work clothes, protective glasses and gloves. Material components must not be in contact with skin and eyes, in case of contact, immediately wash with plenty of soap and water.
Packaging |
345 ml cartridge |
Storage conditions |
12 months in unopened original packaging |
The life time of the mixture |
~ 7-10 minutes (20°C) |
Complete drying |
7 days |
Time re-application |
1 hour 20°C |
Thermostability |
0 °C to 80 °C |
Pressure strength |
60-70 N / mm2 |
The force of adhesion (to concrete) |
≥4 N/mm2 |
Flexural strength |
18-20 N/ mm2 |
Strength on the tension |
≤ 0.6 mm (under a 75 kN load) |
Standard |
In accordance with TS EN 1504-6 |