The repair compound Teknorep 200

Directory > Repair compound for concrete

The repair compound Teknorep 200

Thin layer of one-component repair compound reinforced with polymer fibers.

600
uah
x
bag
=
600 uah
Wholesale price 510 uah from 10 bag

For you, there will be a greater sense of the price of the proposition. Be affectionate, send a request and managers create an individual prorachunok for you.

CHECKOUT

Введите свои данные

Teknorep 200 – single thin layer of repair compound, reinforced polymer fibers.

Applications:

  • Repair of concrete products and structures in all types of engineering structures.
  • Repair damage and cracks of any mineral surfaces.
  • Repair of concrete surfaces after removal of formwork.
  • Repairs of prefabricated elements of reinforced concrete.
  • Elimination of defects with a thickness of 3 to 30 mm.


Advantages

  • Easy to apply.
  • Does not cause corrosion.
  • Suitable for vertical and horizontal applications.
  • Used to produce a smoother surface with minor repairs.
  • Resistant to freezing and thawing.
  • Has high adhesion strength.
  • Has a high compressive strength.


Usage instructions

The surface should be prepared for the application, not contain dust, oil, dirt, rust, mold, grease and waste. The surface should first be primed. 25 kg powder must be 4 - 5 litres of clean water. In a clean container with the water gradually added Teknorep 200. Mixing is carried out using a low shear mixer to obtain a homogeneous mixture. The mixing time shall be not less than 5 minutes. The resulting solution to stand for 3 minutes and mix again for 2 minutes to obtain a homogeneous mixture. In the already prepared mixture do not add water.


Recommendations for the use of

After applying the surface in the first 3 hours must be protected from direct sunlight, strong wind, high air temperature (above 35 ° C), rain and frost.

Reaction time products based on cement depends on the ambient temperature. Reaction time decreases with increasing temperature and increases when it falls.

During application of the product should wear work clothes, appropriate safety rules and industrial hygiene, use protective mask and goggles.

After use, the tool should be immediately cleaned with water. After curing of the mortar, it can be cleaned only mechanically.

The prepared mortar is applied on the surface with a spatula. If necessary, apply a layer of thickness greater than 30 mm, to perform the work in several layers.

Color

Grey

Shelf life

12 months in dry environment in unopened container

Packaging

25 kg bag

Application temperature

( 5 ° C) - ( 35 ° C)

The mixing ratio

4 - 5 l water / 25 kg powder

The density of the solution

Of 2.05 kg/l

The flow rate of the mixture

1.9 kg/m2

Viability

≥ 45 minutes

Commissioning

24 hours

The diameter of the filler

≥ 0.7 mm

The thickness of the coating

10 - 40 mm (one layer)

Flexural strength (EN 12808-3)

7 N/mm2

Bond strength to concrete (EN 1542)

1 N/mm2

Compressive strength (EN 12808-3)

25 N/mm2

Shrinkage (EN 12617-4)

0,8 N/mm2

Capillary absorption (EN 13057)

0.5 kg/m2*h

Fire

A1