Decorative plaster Teknodeko

Directory > Decorative plaster

Decorative plaster Teknodeko

Decorative plaster for interior and exterior wall decoration based on white cement.

384
uah
x
bag
=
384 uah
Wholesale price 326.4 uah from 10 bag

For you, there will be a greater sense of the price of the proposition. Be affectionate, send a request and managers create an individual prorachunok for you.

CHECKOUT

Введите свои данные

Moisture-resistant decorative plaster mixture Teknodeko based on white cement, reinforced with polymer. It is used inside and outside buildings, including on heat and sound insulation materials.

Product Advantages:

  • For plastering of all types of thermal insulation and sound insulation materials
  • For plastering all types of mineral surfaces
  • For horizontal and vertical surfaces
  • For plastering inside and outside buildings

Scope of application:

  • High resistance to any climatic conditions
  • Eliminates all visible surface defects
  • Gives the surface a decorative look
  • It has waterproofing properties
  • Vapor permeable

Surface preparation:

The surface must be dust-free, durable and dry. It must first be cleaned of various contaminants (fats, resins, dust, old paint coatings), which can reduce adhesion. If there are cracks or potholes on the surface, they must be repaired with the appropriate TEKNOREP repair mixes.

Preparation and application:

To prepare the plaster solution, it is necessary to use clean water at room temperature. The dry mixture is gradually poured into a container with water and kneaded with a mixer at low speed for 5 minutes. Let the solution stand for about 5 minutes, and then mix it again until a homogeneous mixture is obtained. For mixing, it is necessary to use the recommended ratio of water and dry mixture.

To apply the material, it is recommended to use spatulas and plaster poluterki. The solution should be applied in a layer that corresponds to the grain size. After removing the excess solution, the surface should be rubbed with horizontal, vertical or circular movements, without wetting with water. The creation of the texture must be performed within 15 minutes after applying the solution to the surface. All work is carried out according to the "wet on wet" method.

Recommendations for use

After applying the material, the surface must be protected from temperatures below 5 °C and above 35 ° C, direct sunlight, strong wind and rain.

After use, the tool must be cleaned immediately with water. After the solution has cured, it can only be cleaned mechanically.

It is recommended to use work clothes, protective gloves, glasses, and a mask to perform the work. 

Colour

White

Packaging

25 kg craft bag

Shelf life

12 months in the closed original packaging

Application temperature

5 °C - 35 °C

Proportions of the mixture

6-6.5 liters of water per 25 kg of dry mix

Thickness of application

2 mm

Impact strength

> 2 J/cm>2 

Water resistance

W3

Fire safety class

A1

Decorative plaster Teknodeko

Other products