Crystallized two-component flexible waterproofing and protective material.
Crystallized two-component flexible waterproofing and protective material Teknomer 200 EX. Forms a seamless flexible waterproofing coating. Creates protection from leaks and penetration of surface waters. Consists of powder component based on cement, the liquid component, based on acrylic and special additives that enhance the workability and water-resistant surface coating.
Applications:
Advantages
Usage instructions
Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks and cavities on surface should be repaired using the easy cement mixes Teknorep 300 and Teknorep 300 EX. If you have an active water leak, it needs to be addressed through Teknoplug.
Before application the surface should be moistened. The application surface should be protected from sun, rain and dust for 1 day and should not be applied under direct sunlight.
The liquid component should be placed in a clean container, proportioning for mixing, slowly add the powder mixture and mixed thoroughly with a slow speed mixer (500 rpm) for 5 minutes. Stand the solution for 3 minutes and continue mixing until a homogeneous mass.
The prepared solution should be applied to the surface in 2 or 3 layers with roller or brush. The direction of deposition of each layer must be perpendicular to the previous one. The time interval between coats of at least 3 hours. The total thickness of drawing of 3 mm will suffice. The corners and joints surface application should be sealed elastic adhesive tape for sealing construction joints Teknomer Pah Band 120/70. After application the surface should be protected from direct sunlight, frost and wind not less than 1 day.
The composition of the material |
Component A: grey powder Component B: white liquid |
Packaging |
25 kg (A) 10 l (In) |
Shelf life |
12 months in dry environment in unopened container |
Application temperature |
( 5 ° C) - ( 35 ° C) |
Consumption |
1.8 kg/m2 (at a thickness of 1 mm) |
The pot life of the mixture |
45 minutes |
Applying the second layer |
3-6 hours |
Ready to use |
7 days |
The density of the mixture |
1.8 kg/l |
Commissioning |
3-7 days |
Adhesive force |
1 N/mm2 |
Penetration into cracks |
≥ 2.5 mm |
Waterproofing |
10 Bar (positive) 10 Bar (negative) |