Penetrating waterproofing Teknomer 100

Directory > Materials for waterproofing

Penetrating waterproofing Teknomer 100

Penetrating the waterproofing compound based on special cements and additives.

996 uah
Wholesale price 846.6 uah from 7 bag

For you, there will be a greater sense of the price of the proposition. Be affectionate, send a request and managers create an individual prorachunok for you.


Введите свои данные

Penetrating waterproofing Teknomer 100 - crystallized single-component waterproofing material based on cement. Surfaces resistance to negative and positive water pressure. Included in the material insoluble crystals fill the pores of the concrete, preventing water penetration.


  • tunnels and Elevator shafts
  • basements and cellars
  • showers and bathrooms
  • pools, wells and water tanks
  • reinforced concrete pipe
  • large engineering structures



  • penetrates deep into the concrete base
  • resistant to positive and negative water pressure
  • can be applied manually or spray

Instructions for use:

Application surface must be cleaned of any oil, dust, detergents and other substances that prevent the adhesion. If there are areas in the form of cracks, cavities on the surface should be repaired with the help of convenient cement mixtures Teknorep 300 and Teknorep 300 EX.

* If the insulated surface is dry, it should be wet. If there is an active leak, it must be eradicated material Teknoplug.

In a clean container add 6-7 liters of water and gradually pour it Teknomer 100, while stirring at low speed with low speed mixer until a homogeneous mass. Mixing time should be at least 5 minutes, then leave the solution for 3 minutes at rest, and mix again for 2 minutes.

  1. The brush

The prepared mixture is applied to the surface with a brush 2-3 layers. The layers should be applied perpendicular to each other.
The wait time between layers is kept below the previous layer does not stick to the fingers.

2. Spraying

Teknomer 100 is sprayed on the prepared surface.

* To use Teknomer 100 as an additive for concrete, it is necessary to pre-mix solution, after adding in the total volume of the mixture Teknomer 100 and additionally mix for 5-7 minutes.

Remarks / Restrictions:

  • Do not use on surfaces made of wood, chipboard, MDF, plywood, PVC and metal.
  • Use gloves, mask and goggles during work
  • Use the recommended proportions for mixing
  • The surface after applying the solution must be protected from adverse weather conditions such as direct sunlight, strong wind, high air temperature (above 35 °C), rain and frost.
  • Used tools and equipment must be cleaned with warm water immediately after use.



Shelf life

12 months in dry environment in unopened container


20 kg bag

Application temperature

( 5 °C) - ( 35 °C)

Mix ratio

6-7 litres water / 20 kg powder

The life time of the mixture

20 min.

Full cure

5 days

Water resistant

7 Bar (positive and negative)



Product publications

On what basis can penetrating waterproofing be used
On what basis can penetrating waterproofing be used

Read article
How to make the waterproofing of the pool. All stages of work
How to make the waterproofing of the pool. All stages of work

The concrete bowl of the pool is almost constantly under water pressure, so the waterproofing will need to comply with strictly on the prescribed technology, and using only the highest quality materials.

Read article
Penetrating waterproofing Teknomer 100

Other products