Installation of formwork over the trench
If the soil in a trench solid and the walls do not fall off, in this case, it is appropriate to do the planking over the trench.
Read articleCiros allows you to quickly attach the formwork of vertical structures and supports the load up to 2 tons.
Chiros — clip to a fixture that allows you to quickly attach the formwork of vertical structures and supports the load up to 2 tons. Allows you to stop or significantly reduce the use of tightening screws, nuts for formwork and the clips. For convenience, it is recommended to use presser key for chiros.
Spring clip is easy to use, saves time during Assembly and disassembly of the formwork of foundations, monolithic belts, walls, columns and concrete stairs.
Advantages:
Recommendations for use:
For installation of spring clamp it is necessary to withdraw the ends of the rebar on the outside of formwork shield to a length of about 15 cm and tighten the retaining key for chiros. Upon completion of the work, removing chiros and dismantling of formwork is needed to cut the ends of the rebar.
Material |
Hardened steel |
Color |
Red |
The size of the plate |
105×72 mm |
The thickness of the plate |
3 mm |
The diameter of the used reinforcement |
6-10 mm |
Load |
2 t |
Weight |
0.3 kg |
If the soil in a trench solid and the walls do not fall off, in this case, it is appropriate to do the planking over the trench.
Read articleFormwork erecting under the current elevation changes on the site, should be at the lowest point higher than at the top.
Read articleOne of the major advantages of spring clamps-cherosov, is that they are reusable.
Read article