Epoxy primer Teknobond 300

Teknobond 300 is a two-component low viscosity epoxy primer that does not contain solvents.

Application areas:

• For concrete surfaces, cement screeds and epoxy solutions
• For normal, glossy and highly absorbent surfaces
• For pre-priming surfaces before applying epoxy and polyurethane coatings

Features and Benefits:

• Low - viscosity
• Penetrating
• It has high adhesive strength
• Does not contain solvents
• Multifunctional
• Suitable for external use
• Easy to use

Instructions for use:

• Before applying the material, the surface should be cleaned of any types of oil, rust, detergents, dirt and other substances that prevent setting.
• The recommended compressive strength of the concrete screed should be from 25 N/mm2, and the tensile strength from 1.5 N/ mm2.
• To prepare the working solution, pour component B into component A and use a low-speed mixer to knead the composition for 2-3 minutes until a homogeneous mass is obtained. 
• The primer can be applied to the surface with a brush, roller or mechanical spray in 2 layers.

Application Notes/Restrictions:

• Do not use the material at temperatures below 3 C. Otherwise, the coating will take a very long time to dry.
• When storing the material at a temperature below 5With the primer, it can crystallize. 
• If direct sunlight hits the surface, the material may burn out. To protect the color, you can apply Teknobond 350. 
• The product may cause irritation if it gets on the skin. It is necessary to use work clothes, protective gloves, a mask and glasses. Before starting work, you can also apply a protective cream on your hands. In case of contact with the eyes, rinse the eyes immediately with warm water and consult a doctor.
• The tools and equipment used must be washed immediately after use.