The finish paint Teknobond 650P

Teknobond 650P is a protective, two-component finishing paint based on polyurethane with high resistance to ultraviolet radiation.

Scope

• As a protective material for all types of metal surfaces.
• As a finishing paint for epoxy base.
• For use in open areas, which require resistance to UV light.

The features and benefits

• Provides excellent adhesion to epoxy and polyurethane surfaces, concrete, asphalt, metal.
• Applied in any manner, whether spray, brush or roller.
• Has a high resistance to UV radiation and temperature changes.
• Resistant to abrasion, impact and chemical compositions.
• Applied to horizontal and vertical surfaces.

Usage instructions

The surface must be dry and free from all kinds of dust, dirt, residues of cement and the lubricating oil with the use of appropriate methods to ensure maximum adhesion strength. The surface must be durable and have adequate compressive strength (minimum 25 N/mm2) and ultimate tensile strength (minimum 1.5 N/mm2).

After adding component B to component A and mix for 2-3 minutes with low speed electric mixer (max 400 rpm) until a homogeneous mixture.

Notes on application / Limitations

• For most high-quality curing of material, do not use the boundary temperature regimes. Low temperatures slow down the curing process, while higher temperatures accelerate the curing process. Viability will also vary depending on the temperature.
• After application the surface should be protected from direct sunlight, strong wind and high air temperature (above 35° C).
• The product can irritate the skin. Use protective glasses or gloves. If your mixture to the skin it should be washed with water with detergent. In case of contact with eyes, rinse with plenty lukewarm water and seek medical help.
• Immediately after application, equipment should be cleaned with solvent Tekno. Tempered equipment can be cleaned only mechanically.