The mixture for leveling floors Teknoself

Directory > The materials for industrial floors

The mixture for leveling floors Teknoself

Self-leveling screed with additives synthetic polymer.

912 uah
Wholesale price 775.2 uah from 10 bag

For you, there will be a greater sense of the price of the proposition. Be affectionate, send a request and managers create an individual prorachunok for you.


Введите свои данные

Teknoself is one component self-levelling mortar for screed with additives synthetic polymer and improved adhesion strength.


  • Used as a levelling screed for the preparation of surfaces under tiles, ceramics, granite, marble, parquet, linoleum, carpet.
  • Used in residential and industrial construction.
  • For areas where you need to pour self-leveling coating with a thickness less than 10 mm.


Features and benefits:

  • Easy to apply.
  • Has self-leveling ability and fast curing.
  • Has high adhesion property.
  • No cracks, even with minimal layer thickness.
  • Makes the surface perfectly smooth.
  • Great for floors with Underfloor heating.


Instructions for use:

Before applying clean the surface from any oil, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks and cavities on surface should be repaired using the easy cement mixes Teknorep 300 and Teknorep 300EX. For better adhesion of the prepared surface must be primed TEKNOLATEX 500 or TEKNOLATEX 300, depending on its structure. Dry surfaces should be slightly dampened. Apply TEKNOSELF should start in 3-4 days.

The prepared material is spread evenly over the primed surface. Before applying it is recommended to eliminate air bubbles using a needle roller. The solution should be mixed using a low speed electric mixer (max 400 rpm) until a homogeneous mass. Gradually add powder material in a container of 5 - 6 liters of water and keep stirring to obtain a homogeneous mixture. The amount of water for mixing may vary depending on the ambient temperature. Solution should be used and spread on the surface for 30 minutes.


Cautions for use:

  • After application it is necessary to protect the surface from adverse weather conditions such as direct sunlight, strong wind, high temperatures (over 35 ° C), rain and frost.
  • Not recommended applying a mixture of a thickness exceeding 10 mm in one layer.
  • You must protect the floor from contact with water after applying the solution.
  • Used tools and equipment must be cleaned with warm water immediately after use.
  • For operation the surface in open spaces it is covered TEKNOCILA 400 to increase resistance to the effects of the environment.
  • Best time of the input surface in operation 24 hours.



Expiration date

12 months in a dry environment in a closed package


25 kg bag

Particle diameter

≤ 0.3 mm

Application temperature

(  5 °C) - (  35 °C)

Mixing ratio

5-6 liters of water / 25 kg of powder

Mixture life time

30 minutes

Solution density

2.08 ± 0.1 kg / pc.

Commissioning period

Approximately 24 hours


1.7 kg / m2 per 1 mm

Application thickness

2-10 mm

Flexural strength (28 days)

≥ 5.0 N / mm2

Compressive strength (28 days)

≥ 25.0 N / mm2 (TS EN 196-1)

Adhesion (28 days)

≥ 2.0 N / mm2